Menu
-
CAR PAINTINGS
-
PAINT AT HOME
- Varnishes for interior wood
- Exterior and marine varnishes for wood
- Exterior wood and deck stains and teak oils
- Enamels for Wood
- Furniture, kitchen cupboards and doors painting
- Chalk colour paint and chalk spray paint
- Anti termites treatments and woodworms protection
- Primers for Wood
- Wood putties
- Clean and Renovate Wood
- Furniture repair
-
PROFESSIONAL PAINT
-
BOAT PAINTING
-
CRAFTS
-
GARDEN
- COLD AND HEAT
-
HARDWARE
-
TOOLS
-
ELECTRICITY
-
PLUMBING AND GAS
- DECORATION
- ORDINATION
-
BATHROOM
- HOME
Search
QUILOSA Sintex PVC adhesive 250 ml
Adhesive based on a PVC resin in solution specially formulated for joining rigid and flexible PVC to each other in pipes, elbows, sleeves, joints, etc., in canalization, sanitation, swimming pools or irrigation works.
Related Products ( 6 other products in the same category )
Description
Adhesive based on a PVC resin in solution specially formulated for joining rigid and flexible PVC to each other in pipes, elbows, sleeves, joints, etc., in canalization, sanitation, swimming pools or irrigation works.
Technical data
Appearance: Colorless liquid of medium viscosity.
Viscosity: Brookfield (Needle 4 at 20 rpm) 6,500 ± 1000 mPa s
Shear strength (24 h): 5 N / mm2
Open time: 2 - 5 minutes
Properties
This product is suitable for pipelines for conducting fluids under pressure and can be used in joints with gaps of up to 0.6 mm.
Specifications
It complies with the UNE-EN 14814 standard: Adhesives for piping systems of thermoplastic materials for pressurized liquid fluids, with a nominal pressure of 16 bar.
Indications of use
Tubes must be chamfered and deburred prior to gluing to ensure a strong and durable joint. Clean the surfaces to be glued using SINTEX CLEANER PVC. Surfaces must be dry before applying adhesive. Shake SINTEX ADHESIVO PVC-U before using. The adhesive should flow slowly from the brush. Apply an even layer of adhesive, first to the inner tube and then to the outer tube, applying generously to the pipe joint. Quickly join parts and butt fit tubes and fittings without twisting, holding tightly until adhesive has eaten.go to dry. The open time of the adhesive depends on the ambient temperature, but it is recommended to bond between 2 and 5 minutes after the adhesive is applied, depending on the environmental conditions. It is recommended to wait at least 24 hours before pressurizing the pipes. It is not advisable to make joints below 5ºC. If it was essential, it would be necessary to carry out a previous conditioning of the pipes and materials to be glued.
Storage
It is recommended to store the product between 5 and 30ºC. Duration: 24 months in hermetically sealed original containers.
Download
No customer questions for the moment.