Polyester putty 2-component filler designed to repair vehicles.
Product with very good adhesion to different surfaces, such as steel and aluminum (after refine and degreasing), galvanized steel (after refine and degreasing), sanded polyester panels and glass (GFK / GRP), polyester putties, rigging acrylic and epoxy existing layers in good condition. Yellow color. Mate.
Product intended for repairs to the bodywork of cars.
Mixing ratio by weight:
- Putty: 100
- Hardener: 2
Mix well until dough is uniform in color. Remove carefully to not incorporate air.
Layer thickness:The mastic can be applied in several thin layers. Before applying the next layer, the previous must be hardened. Sanding before putting the next layer.
Working time of mix: Strong>5-6 minutes at 20C.
Drying time:17 ÷ 19 minutes at 20 ° C. The temperature below 20 ° C significantly reduces the curing time of product.
Sanding:Sanding recess (dry): P80-P120. Finish sanding (dry): P120-P240
Once used polyester putty on it you can apply polyester putty 2-component polyester putty shower 2 component, 2-component acrylic rigging and rigging 2-component epoxy.
Excessive amount of hardener varnish may cause whitening of the surface. During work with the products of two components is recommended personal protective equipment. Avoid contact with eyes and skin. Use only in well-ventilated areas. Tools should be cleaned immediately after use. Product ingredients should be stored in tightly closed container and in the right place. Do not leave in the vicinity of flames or sources of intense heat. Seal the container immediately after using the product. Protect hardener against Global Warmingnto.