Satin water-based varnish of great hardness and flexibility. Good behavior against bumps and scratches. Excellent wetting and adhesion power on wood. Resistant to household chemicals (wine, juices, coffee, oil ...). Does not yellow. Fast dry. Without smell.
Fields of application
Special to give long protection to wooden floors, cork floors or wooden stair treads subjected to intense use.
- Nature: Polyurethane
- Color: Colorless
- Yield: 10-16 m2 / L
- Drying at 23ºC 60% RH (UNE 48301): 30 - 60 minutes
- Repainting at 23ºC 60% RH (UNE 48283): 2 - 3 hours
- Application tools: Brush and Roller
- Dilution: 5% maximum, preferably not dilute
- Cleaning of utensils and dilution: Water
VOC ISO 16000-6 emission: A +
How to use
Stir well in the container. Surfaces must be smooth (sanded), degreased, clean and dry. Apply in thin coats and sand lightly between coats. 2 The moisture content of wood should not exceed 12% in hard wood and 15% in softwood. The varnish has a milky appearance that disappears after a few minutes
Sand the wood in the grain direction, thoroughly clean, remove resins or resin secretions and kill sharp edges. Old unvarnished wood: it is essential to completely remove the dry and gray surface by sanding or brushing thoroughly until the wood in good condition is exposed.
Grind the surface with 30-40 grit sandpaper and refine with 60 and 80 grit sandpaper. Remove dust from sanding. Apply 2 - 3 coats by sanding between coats with 240-280 fine grit sandpaper. Apply the last layer always following the direction of the wood grain.
Maintenance of already painted surfaces in good condition
Lightly sand, remove the generated dust and apply 1 or 2 coats depending on the state of the surface. When old varnishes are catalyzed or polyurethane, it is essential to sand the entire surface thoroughly, to remove them completely.
Maintenance of already painted surfaces in poor condition
Remove completely and proceed as on unprepared surfaces.